Tools Needed To Change Sink Faucet

Turn the valve to the right clockwise to close the valve and shut off the water to the faucet.

Tools needed to change sink faucet.

The wrench allows you to reach into the cramped area behind the sink to loosen or tighten the nuts that hold the faucet to the sink and the nuts that connect the supply lines. But some faucets require only one or two holes and you may not want enough accessories to use the rest. A one hole faucet can be installed in a 3 or 4 hole sink by adding a deck plate but not vice versa. Screw it into place on the drain rim.

A basin wrench is a standard plumbing tool that is indispensable for removing and installing most faucets. Wipe away any excess putty from around the faucet base. Use a basin wrench to loosen up both the hot and cold water supply lines image 2. Turn off the water.

Use a pair of snips or scissors to cut the old plastic sprayer line from the faucet. Check all the connections for leaks and retighten if. If you re replacing the faucet in your existing sink look underneath the sink to see how many holes it has usually between 1 and 4. This gets rid of debris or sediment in the faucet.

Follow the manufacturer s directions to mount the new faucet then remount the sink with the new faucet and hook up the water lines as we show in this how to replace a kitchen faucet project. Depending on your plumbing you may have a single water valve for the entire faucet or you may have two separate valves for the hot and cold water. You can buy plugs for unused holes but they usually don t match the sink. Apply clear silicone to the underside of the drain collar.

Then turn the ratchet and it will self. It works quickly and easily and you avoid backaches. Buy this cool tool a special faucet nut wrench to simplify faucet removal under those hard to reach sinks. Match faucet to sink openings.

From beneath the sink tighten the mounting nuts to keep the faucet in place. Tip with most faucets only three of the four holes are covered so you ll either need to get a blank insert or use the extra hole for a liquid soap. Use a basin wrench or a sink installer tool being careful to not over tighten the nuts. It should be under the sink inside the vanity.

Locate the water shutoff valve for the bathroom sink. Shut off the water. Have a bucket handy to catch the water. Remove the old faucet supply lines image 1 which will expose the holes in the sink.

The faucet nuts are located above the water supply line connections and these nuts are what holds your faucet in place. Wipe away excess silicone. Most sinks have three holes for the faucet and a fourth for an accessory such as a sprayer or a soap dispenser. Flush the faucet by removing the aerator.

Turn on the hot and cold water for about a minute. This determines the type of faucet that will work with your sink. Some faucets include a handy little tool to unscrew the aerator. Unscrew the lines from the faucet.