Tongue And Groove Gate Plans

This timber is called 4 x 1 treated timber in the builders yards and timber merchants where you will find it is a lot cheaper than places like homebase and b q.

Tongue and groove gate plans.

To produce the tongue the spindle block is lifted and then the boards go through face down. And the black hardware beautifully contrasts with the red cedar. Plus the tongue and groove cedar boards ensure privacy as no one will be able to peek through slats in the gate. Flip the boards over and repeat on the other face.

Next we ll cut the tongue that will make up this tongue and groove joint. Step 2 run a bead of glue inside the all the grooves using the tip of a glue bottle. For a gate approx 1m wide ours was actually 900mm you will need 5m. This project provides instructions to create a 42 inch wide cedar wood gate that will add style and function to a fence.

Use a 3 4 inch chisel to clear out any material in the groove. Lay nine pieces of tongue and groove wood face down parallel to each other on a flat surface. Unfinished pine tongue and groove shiplap siding board 6 pack model 276588 view the ufp edge unfinished tongue groove. In a router you can ignore this as the boards should go through face down.

Match the tongue on one board with the groove on the other board.